Nasirian_Mohsen.pdf (6.5 MB)

Development of a novel photocatalyst for the photocatalytic treatment of industrial wastewater

Download (6.5 MB)
thesis
posted on 22.05.2021, 14:36 by Mohsen Nasirian
Heterogeneous semiconductor photocatalysts have been shown to be efficient for the degradation of refractory organics into simple compounds. Among all photocatalysts, TiO2 is the most used one. Two issues that arise with the use of unmodified TiO2 as a photocatalyst are the unwanted fast recombination of electron/hole pairs and the lower effectiveness in the presence of visible light irradiation. Doping a transition metal or a non-metal into TiO2 and its combination with another photocatalyst have been used to enhance its photoactivity. This study is to develop a new photocatalyst by the combination of TiO2 with another semiconductor oxide (Fe2O3) and its doping with transition metal such as Ag. Combined photocatalysts of Fe2O3 /TiO2 (with different mass ratio of Fe:TiO2) is synthesized and then silver ion is doped to combine photocatalysts (with different mass ratio of Ag:TiO2) to produce a new composite photocatalyst of Ag/TiO2/Fe2O3. A new method of UV-assisted thermal synthesis is also employed to prepare the new composite photocatalyst. Methyl orange (MO) and Congo red (CR), as model pollutants, are used to test the developed photocatalyst. In addition, nitrogen-doped titanium dioxide photocatalyst (N-TiO2) with heterojunction structures is synthesized by three different approaches including new UV-assisted thermal synthesis, annealing, and microwave techniques. The novel UV-assisted thermal synthesis has produced encouraging results as a preparation method to prepare N-TiO2 at lower temperature and atmospheric pressure as well as a lower cost. Design of Experiment (DOE) along with response surface methodology (RSM) is used to optimize the photocatalytic activity of N-TiO2 as well as the affecting parameters (wavelength, light intensity, pH, and initial TOC) for decomposition of organics. The structure of all synthesized composite photocatalysts are investigated by X-ray diffraction (XRD). Scanning electron microscopy (SEM) combined with energy-dispersive X-ray spectroscopy (EDS) is employed to evaluate surface characteristics and elemental analysis of synthesized photocatalysts. Specific surface area of photocatalysts is measured based on Brunauer, Emmett and Teller (BET) technique. Results show that bare TiO2 has the lowest photocatalytic activity in degradation of organics. When silver is doped to TiO2, the degradation of MO is slightly enhanced at specific mass ratio. The presence of Fe2O3 in the new composite causes a red shift and enhances the potential to absorb higher range of visible light. Results from XRD confirmed that Fe3+ substitutes with Ti4+ in the crystal lattice of TiO2 and crystal defect occurs. The degradation of MO in presence of Ag/TiO2/Fe2O3 (Ag/TiO2=0.005 w:w and Fe:TiO2= 0.01 w:w) reached to 95.6% under sunlight in three hours with a red shift towards visible light. It is observed that there is an optimum specific surface area of photocatalysts by doping and combining photocatalysts.

History

Language

eng

Degree

Doctor of Philosophy

Program

Environmental Applied Science and Management

Granting Institution

Ryerson University

LAC Thesis Type

Dissertation